A funicular (//) is a transportation system designed for steep inclines — specifically using two counterbalanced and track-guided passenger cars permanently attached to the ends of a single cable — which is looped over a pulley at the upper end and is powered by a cable traction system. A number of tracking alternatives enable side by side passage of the funicular's two cars.
A funicular's two cars move in concert: as one ascends, the other descends simultaneously, an arrangement that distinguishes a funicular from other cable-guided transportation systems — e.g., a single car inclined elevator.
As a funicular's two cars are attached to each other by a cable, which runs through a pulley at the top of the slope, the arrangement counterbalances the two cars and minimizes the energy needed to lift the ascending car. An electric drive winches the cable and turns the pulley. Sheave wheels guide the cable to and from the drive mechanism and the cars.
Early funiculars used two parallel straight tracks, four rails, with separate station platforms for each vehicle. The tracks are laid with sufficient space between them for the two cars to pass at the midpoint. Three-rail arrangement was also used to overcome the half-way passing problem.
The wheels of the cars are usually single-flanged, as on standard railway vehicles. Examples of this type of track layout are the Duquesne Incline in Pittsburgh, Pennsylvania, and most cliff railways in the UK.
The Swiss engineer Carl Roman Abt invented the method that allows cars to be used with a two-rail configuration: the outboard wheels have flanges on both sides, which keeps them aligned with the outer rail, thereby holding each car in position, whereas the inboard wheels are unflanged and ride on top of the opposite rail, easily crossing over the rails (and cable) at the passing track.
Two-rail configurations of this type avoid the need for switches and crossings, since the cars have the flanged wheels on opposite sides and will automatically follow different tracks, and in general, significantly reduce costs.
In layouts using three rails, the middle rail is shared by both cars. The three-rail layout is wider than the two-rail layout, but the passing section is simpler to build. If a rack for braking is used, that rack can be mounted higher in a three-rail layout, making it less sensitive to choking in snowy conditions.
Some four-rail funiculars have the upper and lower sections interlaced and a single platform at each station. The Hill Train at Legoland, Windsor, is an example of this configuration.
The track layout can also be changed during the renovation of a funicular, and often four-rail layouts have been rebuilt as two- or three-rail layouts; e.g., the Wellington Cable Car in New Zealand was rebuilt with two rails.
The cars can be attached to a second cable running through a pulley at the bottom of the incline in case the gravity force acting on the vehicles is too low to operate them on the slope. One of the pulleys must be designed as a tensioning wheel to avoid slack in the ropes. In this case, the winching can also be done at the lower end of the incline. This practice is used for funiculars with slopes below 6%, funiculars using sledges instead of cars, or any other case where it is not ensured that the descending car is always able to pull out the cable from the pulley in the station on the top of the incline. Another reason for a bottom cable is that the cable supporting the lower car at the extent of its travel will potentially weigh several tons, whereas that supporting the upper car weighs virtually nothing. The lower cable adds an equal amount of cable weight to the upper car while deducting the same weight from the lower, thereby keeping the cars in equilibrium.
A few funiculars have been built using water tanks under the floor of each car that are filled or emptied until just sufficient imbalance is achieved to allow movement. The car at the top of the hill is loaded with water until it is heavier than the car at the bottom, causing it to descend the hill and pulling up the other car. The water is drained at the bottom, and the process repeats with the cars exchanging roles. The movement is controlled by a brakeman.
The Giessbachbahn in the Swiss canton of Berne, opened in 1879, originally was powered by water ballast. Later on it was converted to electrical power. The Bom Jesus funicular built in 1882 near Braga, Portugal is another example.
Funicular railways operating in urban areas date from the 1860s. The first line of the Funiculars of Lyon (Funiculaires de Lyon) opened in 1862, followed by other lines in 1878, 1891 and 1900. The Budapest Castle Hill Funicular was built in 1868–69, with the first test run on 23 October 1869. In Istanbul, Turkey, the Tünel has been in continuous operation since 1875 and is both the first underground funicular and the second-oldest underground railway. The oldest funicular railway operating in Britain dates from 1875 and is in Scarborough, North Yorkshire.
Until the end of the 1870s, the four-rail parallel-track funicular was the normal configuration. Carl Roman Abt developed the Abt Switch allowing the two-rail layout, which was used for the first time in 1879 when the Giessbach Funicular opened in Switzerland.
In the United States, the first funicular to use a two-rail layout was the Telegraph Hill Railroad in San Francisco, which was in operation from 1884 until 1886. The Mount Lowe Railway in Altadena, California, was the first mountain railway in the United States to use the three-rail layout. Three- and two-rail layouts considerably reduced the space required for building a funicular, reducing grading costs on mountain slopes and property costs for urban funiculars. These layouts enabled a funicular boom in the latter half of the 19th century.
In 1880 the funicular of Mount Vesuvius inspired the song Funiculì, Funiculà, composed by Luigi Denza and lyrics by Peppino Turco. This funicular was destroyed repeatedly by volcanic eruptions and abandoned after the eruption of 1944.
An inclined elevator is not a funicular, since its cars operate independently on the slope, not in interconnected pairs.
For example, despite its name the Montmartre Funicular in Paris, following the 1991 reconstruction, is technically a double inclined elevator since its cabins do not counterbalance each other and operate independently: each of them has its own cable traction and counterweight.
Valparaiso in Chile, which used to have up to 30 funicular elevators (Spanish: ascensores), is the oldest, dating from 1883. 15 remain with almost half in operation, and others in various stages of restoration.
The Carmelit in Haifa, Israel, with six stations and a tunnel 1.8 km (1.1 mi) long, is claimed by the Guinness World Records as the "least extensive metro" in the world. Technically, it is an underground funicular.
The Telegraph Hill Railroad was not a cable car line ...; it was a funicular railway